Enabling Zoning Using Windows - Western Digital Ultrastar Data102 User Manual

User Guide
c. Zone groups will not be visible due to zoning being disabled. All hosts will have access
d. Issue the following command to access all hosts smp_discover_list:
5.3.6 Enabling Zoning using Windows
Step 1 : From the host server, identify the SCSI devices that are associated with the Ultrastar Data102
IOMs.
a. Issue the following command:
b. Identify the SCSI devices from the output. The device information follows SCSI0. The
Step 2 : Locate the IP Address for each IOM using sg_ses page 7.
a. Issue the following command:
b. The IP Address for each IOM will appear at the end of each resulting line. Each IP
smp_discover_list /dev/bsg/expander-9:39
Note: Repeat this substep for all expanders.
to all drives.
smp_discover_list --ignore /dev/bsg/expander-9:39
Note: Repeat this substep for all hosts.
Note: The operating system associates each SEP device as a SCSI device. The
SCSI device of the SEP can be used to get status from or control elements
within the enclosure.
sg_scan -s | findstr /i H4102-J
devices appear as SCSI0:1,62,0 and SCSI0:1,124,0 bolded in the example below.
SCSI0:1,62,0 claimed=0 pdt=dh
0101
0428
SCSI0:1,124,0 claimed=0 pdt=dh
0101
0428
sg_ses <dev> -p7 | finstr /i esce
Note: For scsi<dev>, type the number of the SCSI device recorded in
the previous step.
Address is labeled for either IOM A or IOM B and occurs after the last comma as seen
bolded in the following example.
5. System Management
HGST H4102-J
HGST H4102-J
5.3 Zoning
213