Western Digital Ultrastar Data102 User Manual page 159

User Guide
c. Slide the inner rail toward the rear of the chassis to lock it in place. There will be an
audible click and the mounting pegs will cover the front part of the keyhole.
d.
Install the three special low-profile M4 x 3.2mm Philips screws provided to secure the
inner rail to the chassis.
e. Follow these steps for the second inner rail on the opposite side of the enclosure.
Step 27 : Attach a cable tie mount to the cable tray.
a. Clean the surface of the cable tray, under the mounting area, with isopropyl alcohol and
allow to dry.
b. Adhere a cable tie mount in the approximate location shown in the following diagram:
Figure 165: Inner Rail Attachment
Figure 166: Slide Inner Rail
Caution: When installing the inner rail onto the chassis, make sure to only
use the special Low-Profile M4 x 3.2mm Philips screws provided in the
accessory kit with the CMA. These screws should be tightened to .90-1.12
Nm / 8-10 in-lbf using a # 2 Philips Screwdriver. These screws are specially
designed for this purpose. Using unapproved screws could cause damage
to the slides inside the rail.
4. Part Replacement
4.9 Chassis Replacement
149