Western Digital Ultrastar Data102 User Manual page 140

User Guide
a. Press the blue latch button labeled "push" to unlatch the elbow side of the CMA arm, and
then swing the arm open.
b. Open all of the baskets.
c. Gather the SAS, power, and Ethernet cables for installation.
d. Connect the Ethernet cables to the Ethernet ports on the left hand side of the Ultrastar
Data102, and then route the cables through each of the baskets on the arm.
Figure 137: Open Baskets
Note: Route all cables to IOM A (left hand side looking at the rear).
4. Part Replacement
4.8 Rails Replacement
130