Western Digital Ultrastar Data102 User Manual page 105

User Guide
d. Connect the Ethernet cable to the Ethernet port, and route the cable through each of the
baskets on the arm.
e. Connect the SAS cables to the SAS ports, and route them through the baskets one at a
time. Make sure to follow the labels to ensure they are connected to the proper ports.
f. Connect the power cable to the PSU and route it through each basket.
g. If the installation includes more than 10 total cables, follow the recommendations in
Special Considerations for Cable Routing (page
Figure 88: Open Baskets
Attention: Make sure the power cable is not connected to a PDU. If it
is, the system will power up when the cable is connected to a PSU. This
is not intended at this stage of installation.
Note: Each cable must be given enough slack at the connector end
to operate smoothly. Allow 20 - 21 in. (508 – 533.4 mm) between the
connector and the first basket.
4. Part Replacement
4.7 CMA Replacement
174), before proceeding.
95