Western Digital Ultrastar Data102 User Manual page 100

User Guide
b. Slide the nut plate down over the mounting pin on the back of the spacer bracket.
c. Using a T15 Torx screwdriver, tighten the top captive screw to secure the mounting plate
in place. Then tighten the remaining captive screws at the bottom of the spacer bracket.
Torque all four of the captive screws to 3.38-3.61 Nm / 30-32 in-lbf.
d. Repeat these steps to install the remaining rack spacer.
Step 13 : Install the chassis into the rails.
Figure 81: Rack Spacer Nut Plate Installation
Figure 82: Captive Screws
4. Part Replacement
4.7 CMA Replacement
90