Western Digital Ultrastar Data102 User Manual page 166

User Guide
b. Ensure that the handles on the IOM are not latched. To unlatch them, press the latch
release in the direction shown in the following image.
c. Align the IOM with the empty slot on the top of the chassis so that the arrow on the IOM
latch release is facing toward the side shown in the following image.
d. Slowly lower the IOM into the empty slot while being careful to keep it level. Do not to
force it.
e. When the IOM is lowered fully, apply light pressure with both hands evenly on the IOM
body, not the handles, to seat the IOM in the connector. If the IOM won't seat correctly,
DO NOT FORCE IT. Instead, back the IOM out, check the pins to make sure none are
damaged, and try again.
f. Once the IOM is seated properly in the slot, close the handles until they latch closed.
Step 36 : Install the second IOM using the same method as the first.
Step 37 : Install the IOM Fan.
a. Align the IOM Fan as shown in the following image.
Figure 176: Unlatching IOM Handles
Figure 177: Installing the IOM
4. Part Replacement
4.9 Chassis Replacement
156