Western Digital Ultrastar Data102 User Manual page 160

User Guide
Step 28 : Secure the Cable Tray onto the enclosure using the included M3 x 8mm T10 Torx screws and the
Long T10 Torx Screwdriver. These screws should be tightened to .33-.56 Nm / 3-5 in-lbf using a
Long T10 Torx Screwdriver.
Figure 168: Installing the Cable Tray
Step 29 : Extend the mid-rails out of the rack so that they are protruding from the front of the rack and the
safety latches engage.
Figure 167: Cable Tie Mount Location
4. Part Replacement
4.9 Chassis Replacement
150