Western Digital Ultrastar Data102 User Manual page 95

User Guide
Step 8 : Follow the previous step for each drive in the enclosure. Attach a label or mark the drives with
the drive slot they were removed from in order to add them to the same slot in the future. Store
the drives in an ESD safe location until the drives are ready to be installed back into an enclosure.
Step 9 : Release the safety latch on the inner rails on each side of the chassis as shown in the following
image.
Step 10 : Remove the chassis from the rack.
a. Be prepared to support the enclosure once it is free of the rails by having a second
person or a lift to support the enclosure
b. Grasp both handles at the front of the enclosure and pull with even pressure until the
enclosure will not extend further.
c. Locate the safety catches on the inner rails attached to the enclosure.
Figure 74: Inner Rail Safety Latch Release
Warning:
not intended to be used to support the weight of the Ultrastar
Data102. Lifting the unit by the chassis handles or trying to support
the unit on the handles can cause them to fail. This can cause
serious damage to the unit or serious bodily harm to those
handling the unit. Always team lift the chassis by gripping the
underside of the unit, and never try to lift a chassis that is filled with
drives.
The handles on the front of the chassis are
4. Part Replacement
4.7 CMA Replacement
85