Western Digital Ultrastar Data102 User Manual page 236

User Guide
Step 2 : Locate the area that the new drives will be installed into. When adding SSDs, the drives slots
may already contain a drive. The drive will have to be removed and relocated before installing
the HDD.
Step 3 : Follow the requirements for partial populations listed in
222).
Step 4 : Install the Drive Assembly.
a. Ensure that the enclosure has been pulled out of the rack until the rail latches engage.
b. Find the LED pointer on the top of the drive carrier. This pointer should point toward the
front of the unit as shown in the following image.
Figure 225: Chassis Handle Operation
Figure 226: LED Pointer Orientation
5. System Management
5.5 Partially Populated Enclosures
Partial Population Configurations (page
226