Western Digital Ultrastar Data102 User Manual page 165

User Guide
c. Slowly slide the enclosure forward to ensure the arm is operating properly, then slide it
back into the rack.
a. CMA Standard: Repeat these steps to install the upper arm with the elbow facing to the
right.
Step 34 : Grasp both handles at the front of the enclosure and pull with even pressure to extend the
chassis out of the rack until it is stopped by the safety latches. The safety latches will prevent the
enclosure from coming out of the rack completely and the cover will remain in the rack attached
to the rear alignment brackets.
Step 35 : Install the IOM.
a.
Figure 174: Lower CMA Orientation
Figure 175: Chassis Handle Operation
Caution: If a pin on the IOM's internal connectors is bent or damaged, the
IOM will have to be replaced. For this reason it is imperative that the IOM is
not forced into position, that it is inserted straight, and that the directions for
installing the IOM are followed exactly.
4. Part Replacement
4.9 Chassis Replacement
155