Cutting Edge Data - Siemens SINUMERIK Series Operating Manual

Tool management
13.9 Tool details
Parameter
Magazine location
Tool name
ST
D quantity
D
Tool state
Tool size
Tool OEM parameters
1 - 6
13.9.3

Cutting edge data

The "Tool Details" window provides the following data on the selected tool when the "Cutting
edge data" softkey is active.
Parameter
Magazine location
Tool name
ST
D quantity
D
Tool type
724
Meaning
The magazine number is specified first, followed by the location number in the magazine.
If there is only one magazine, only the location number is displayed.
The tool is identified by the name and the sister tool number. You can enter the name as text or
number.
Sister tool number (for sister tool strategy)
Number of created cutting edges
Cutting edge number
A Activate tool
F Tool enabled
G Block tool
M Measure tool
V Reaching the prewarning limit
W Tool being changed
P Tool in fixed location
The tool is permanently assigned to this magazine location
I Tool has been in use
Standard Tool does not require an additional location in a magazine.
Oversize The tool occupies two half locations left, two half locations right, one half
location top and one half location bottom in a magazine.
Special size
Left Number of half locations to the left of the tool
Right Number of half locations to the right of the tool
Freely available pa‐
rameters
Meaning
The magazine number is specified first, followed by the location num‐
ber in the magazine.
If there is only one magazine, only the location number is displayed.
The tool is identified by the name and the sister tool number. You
can enter the name as text or number.
Sister tool number (for sister tool strategy)
Number of created cutting edges
Cutting edge number
Tool symbol with type number
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
Milling