Program Control During The Simulation; Changing The Feedrate - Siemens SINUMERIK Series Operating Manual

Hide thumbs Also See for SINUMERIK Series:

Table of Contents

Program control during the simulation

You have the capability of changing the feedrate at any time during the simulation.

You track the changes in the status bar.

If you are working with the "Simultaneous recording" function, you use the rotary switch

(override) on the control panel.

Toggling between "Override +" and "Override -"

Selecting the maximum feedrate

Operating Manual, 08/2018, 6FC5398-7CP41-0BA0

Simulation is started.

Press the "Program control" softkey.

Press the "Override +" or "Override -" softkey to increase or decrease the

feedrate by 5%, respectively.

Press the "100% override" softkey to set the feedrate to 100%.

Press the "<<" softkey to return to the main screen and perform the sim‐

ulation with changed feedrate.

Simultaneously press the <Ctrl> and <cursor down> or <cursor up> keys to

toggle between the "Override +" and "Override -" softkeys.

Press the <Ctrl> and <M> keys simultaneously to select the maximum fee‐

drate of 120%.

Simulating machining

7.7 Program control during the simulation