Siemens SINUMERIK Series Operating Manual page 390

Programming technological functions (cycles)
10.1 Drilling
Parameter Description
Through drilling ● Yes
Through drilling with feedrate FD
● No
Drilling with constant feedrate
ZD - (only for Depth for feedrate reduction (abs) or depth for feedrate reduction in relation to Z1
through drilling (inc)
"yes")
FD - (only for Feedrate for through drilling referred to drilling feedrate F.
through drilling
Feedrate for through drilling (ShopMill)
"yes")
Feedrate for through drilling (G code).
DT - (only for
● Dwell time at final depth in seconds
through drilling
● Dwell time at final depth in revolutions
"no")
Retraction
● Retraction to pilot hole depth
● Retraction to retraction plane
FR Retraction (G code)
● with rapid traverse
● Feedrate for retraction
Retraction (ShopMill)
● with rapid traverse
● Feedrate for retraction
SR / VR
Coolant off - M9 - M function to switch off the coolant
(only G code)
Parameters in the "Input simple" mode
G code program parameters
Input
390
Retraction with sta‐
tionary spindle
Direction of spindle Spindle speed for retraction to the drilling speed
rotation during re‐
Spindle speed for retraction
traction
Constant cutting rate for retraction (G code)
Constant cutting rate for retraction (ShopMill)
● simple
ShopMill program parameters
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
Unit
mm
%
mm/min or mm/rev.
distance/min or dis‐
tance/rev
s
U
distance/min
mm/min
%
rpm
distance/min
m/min
Milling