Siemens SINUMERIK Series Operating Manual page 630

Programming technological functions (cycles)
10.5 Contour turning - Milling/turning machine
Parameter Description
XDB Second grooving limit tool ∅ (abs) – (end face or rear face only)
Allowance Allowance for prefinishing
● Yes
U1 contour allowance
● No
DI For zero: Continuous cut - (only for ∇)
XD - (only for blank description, cylinder and allowance)
● For blank description, cylinder
–
–
● For blank description, allowance
–
–
ZD - (only for blank description, cylinder and allowance)
● For blank description, cylinder
Allowance or cylinder dimension (abs or inc)
● For blank description, allowance
Allowance on the contour (abs or inc)
U1 Compensation allowance in X and Z direction (inc) – (only for allowance)
● Positive value: Compensation allowance is retained
● Negative value: Compensation allowance is removed in addition to finishing allowance
Set machining Set machining area limits
area limits
● Yes
● No
With limited machining area only, yes:
XA 1st limit XA ∅
XB 2nd limit XB ∅ (abs) or 2nd limit referred to XA (inc)
ZA 1st limit ZA
ZB 2nd limit ZB (abs) or 2nd limit referred to ZA (inc)
N Number of grooves
DP Distance between grooves (inc)
* Unit of feedrate as programmed before the cycle call
630
Allowance or cylinder dimension ∅ (abs)
Allowance or cylinder dimension (inc)
Allowance on the contour ∅ (abs)
Allowance on the contour (inc)
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
Unit
mm
mm
mm
mm
mm
mm
mm
Milling