Siemens SINUMERIK Series Operating Manual page 387

Procedure
Parameters in the "Input complete" mode
G code program parameters
Input
PL Machining plane
RP Retraction plane
SC Safety clearance
F Feedrate
S / V Direction of spindle rotation
during drilling
Spindle speed /
Constant cutting rate
Parameter Description
Machining
● Single position
position (only
Drill hole at programmed position
for G code)
● Position pattern with MCALL
Z0 (only G Reference point Z
code)
Drilling depth
● Shank (drilling depth in relation to the shank)
The drill is inserted into the workpiece until the drill shank reaches the value
programmed for Z1. The angle entered in the tool list is taken into account.
● Tip (drilling depth in relation to the tip)
The drill is inserted into the workpiece until the drill tip reaches the value
programmed for Z1.
Z1 Final drilling depth (abs) or final drilling depth in relation to Z0 (inc)
It is inserted into the workpiece until it reaches Z1.
Coolant on - M function to switch on the coolant.
(only G code)
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
1. The part program or ShopMill program to be processed has been created
and you are in the editor.
2. Press the "Drilling" softkey.
3. Press the "Deep-hole drilling" and "Deep-hole drilling 2" softkeys.
The "Deep-hole Drilling 2" input window opens.
● Complete
mm
mm
distance/min
distance/rev
rpm
distance/min
Programming technological functions (cycles)
ShopMill program parameters
T Tool name
D Cutting edge number
F Linear feedrate
Revolutional feedrate
S / V Spindle speed /
Constant cutting rate
10.1 Drilling
mm/min
mm/rev
rpm
m/min
Unit
mm
mm
387