Siemens SINUMERIK Series Operating Manual page 427

Parameter Description
Solid machining ● Complete machining
(for roughing only)
The rectangular pocket is milled from the solid material.
● Post machining
A rectangular pocket or hole has already been machined in the workpiece. This needs
to be enlarged in one or several axes. You must program parameters AZ, W1 and
L1 for this purpose.
AZ Depth of premachining – (for remachining only)
W1 Width of premachining – (for remachining only)
L1 Length of premachining – (for remachining only)
FS Chamfer width for chamfering - (for chamfering only)
ZFS Insertion depth of tool tip (abs or inc) – (for chamfer only)
* Unit of feedrate as programmed before the cycle call
Parameters in the "Input simple" mode
G code program parameters
Input
Milling direction
RP Retraction plane
F Feedrate
Parameter Description
Machining The following machining operations can be selected:
● ∇ (roughing)
● ∇∇∇ (finishing)
● ∇∇∇ edge (edge finishing)
● Chamfering
The positions refer to the reference point:
X0 Reference point X – (single position only)
Y0 Reference point Y – (single position only)
Z0 Reference point Z – (only single position and G Code position pattern)
W Pocket width
L Pocket length
R Corner radius
Z1 Depth referred to Z0 (inc) or pocket depth (abs) - (only for ∇, ∇∇∇ or ∇∇∇ edge)
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
● simple
mm
*
Programming technological functions (cycles)
ShopMill program parameters
T Tool name
D Cutting edge number
F Feedrate
S / V Spindle speed or constant
cutting rate
10.2 Milling
Unit
mm
mm
mm
mm
mm
mm/min
mm/rev
rpm
m/min
mm
mm
mm
mm
mm
mm
mm
427