Assigning The Machining Plane; Setting The Tolerance; Selecting The Machining Range / Deleting The Range And Element - Siemens SINUMERIK Series Operating Manual

6.11.3.3

Assigning the machining plane

You can select the machining plane in which the contour created with the DXF reader should
be located.
Procedure
6.11.3.4

Setting the tolerance

To allow even inaccurately created drawings to be used, i.e. to compensate for gaps in the
geometry, you can enter a snap radius in millimeters. This relates elements.
Note
Large snap radius
The larger that the snap radius is set, the larger the number of available following elements.
Procedure
6.11.3.5

Selecting the machining range / deleting the range and element

You can select ranges in the DXF file and therefore reduce the elements. After accepting the
2nd position, only the contents of the selected rectangle are displayed. Contours are cut to the
rectangle.
Requirement
The DXF file is open in the editor.
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
1. The DXF file is opened in the editor.
2. Press the "Select plane" softkey.
The "Select Plane" window opens.
3. Select the desired plane and press the "OK" softkey.
1. The DXF file is opened in the editor.
2. Press the "Details" and "Snap radius" softkeys.
The "Input" window appears.
3. Enter the desired value and press the "OK" softkey.
Machining the workpiece
6.11 Working with DXF files
231