Table of Contents
Advertisement
444
8-2. Steps to take in an emergency
vehicle and connect the clamp at the other end of the negative cable to
.
Positive (+) battery terminal (your vehicle)
Positive (+) battery terminal (second vehicle)
Negative (-) battery terminal (second vehicle)
Solid, stationary, unpainted metallic point away from the battery and any
moving parts as shown in the illustration
4
Start the engine of the second
vehicle. Increase the engine
speed slightly and maintain at
that level for approximately 5
minutes to recharge the 12-volt
battery of your vehicle.
5
Vehicles with a smart entry &
start system: Open and close
any of the doors of your vehicle
with the power switch OFF.
6
Maintain the engine speed of
the second vehicle and start the
hybrid system of your vehicle by
turning the power switch to ON.
7
Make sure the "READY" indica-
tor comes on. If the indicator
COROLLA HV_ 国瑞 _GE
COROLLA HYBRID_OM_General_OM12M44E
does not come on, contact your
Toyota dealer.
8
Once the hybrid system has
started, remove the jumper
cables in the exact reverse
order from which they were con-
nected.
Once the hybrid system starts,
have the vehicle inspected at your
Toyota dealer as soon as possible.
■
Starting the hybrid system when
the 12-volt battery is discharged
The hybrid system cannot be started by
push-starting.
■
To prevent 12-volt battery dis-
charge
Turn off the headlights and the audio
●
Advertisement
Table of Contents
