Table of Contents
Advertisement
426
8-2. Steps to take in an emergency
pressor switch off and contact your
Toyota dealer.
If the tire inflation pressure exceeds the
specified air pressure, let out some air
to adjust the tire inflation pressure.
(P.427, 458)
15With the compressor switch off,
disconnect the hose from the
valve on the tire and then pull
out the power plug from the
power outlet socket.
Some sealant may leak when the hose
is removed.
16Install the valve cap onto the
valve of the emergency repaired
tire.
17Attach the air release cap to the
end of the hose.
If the air release cap is not attached,
the sealant may leak and the vehicle
may get dirty.
18Temporarily store the bottle in
the trunk while it is connected to
the compressor.
19To spread the liquid sealant
evenly within the tire, immedi-
ately drive safely for about 5 km
(3 miles) below 80 km/h (50
mph).
20After driving, stop your vehicle in
a safe place on a hard, flat sur-
COROLLA HV_ 国瑞 _GE
COROLLA HYBRID_OM_General_OM12M44E
face and reconnect the repair
kit.
Remove the air release cap from the
hose before reconnecting the hose.
21Turn the compressor switch on
and wait for several seconds,
then turn it off. Check the tire
inflation pressure.
If the tire inflation pressure is
under 130 kPa (1.3 kgf/cm
bar, 19 psi): The puncture can-
not be repaired. Contact your
Toyota dealer.
If the tire inflation pressure is
130 kPa (1.3 kgf/cm
psi) or higher, but less than the
specified air pressure: Proceed
to step 22.
If the tire inflation pressure is the
specified air pressure (P.458):
Proceed to step 23.
2
or
2
or bar, 19
Advertisement
Table of Contents
