Table of Contents
Advertisement
shown. (P.458)
12Start the hybrid system.
(P.166, 168)
13To inject the sealant and inflate
the tire, turn the compressor
switch on.
COROLLA HV_ 国瑞 _GE
COROLLA HYBRID_OM_General_OM12M44E
8-2. Steps to take in an emergency
14Inflate the tire until the specified
air pressure is reached.
The sealant will be injected and
the pressure will spike to
between 300 kPa (3.0 kgf/cm
or bar, 44 psi) and 400 kPa (4.0
2
kgf/cm
or bar, 58 psi), then
gradually decrease.
The air pressure gauge will dis-
play the actual tire inflation pres-
sure about 1 to 5 minutes after
the switch is turned on.
Turn the compressor switch off and
then check the tire inflation pressure.
Being careful not to over inflate, check
and repeat the inflation procedure until
the specified tire inflation pressure is
reached.
The tire can be inflated for about 5 to 20
minutes (depending on the outside tem-
perature). If the tire inflation pressure is
still lower than the specified point after
inflation for 25 minutes, the tire is too
damaged to be repaired. Turn the com-
425
2
8
Advertisement
Table of Contents
