Table of Contents
Advertisement
168
4-2. Driving procedures
Power (ignition) switch
(vehicles with a smart
entry & start system)
Performing the following oper-
ations when carrying the elec-
tronic key on your person
starts the hybrid system or
changes power switch modes.
Starting the hybrid system
1
Check that the parking brake is
set. (P.177, 178)
2
Check that the shift lever is in P.
3
Firmly depress the brake pedal.
and a message will be displayed
on the multi-information display. If it is
not displayed, the hybrid system cannot
be started.
4
Press the power switch shortly
and firmly.
When operating the power switch, one
short, firm press is enough. It is not
necessary to press and hold the switch.
If the "READY" indicator turns on, the
hybrid system will operate normally.
Continue depressing the brake pedal
until the "READY" indicator is illumi-
nated.
The hybrid system can be started from
COROLLA HV_ 国瑞 _GE
COROLLA HYBRID_OM_General_OM12M44E
any power switch mode.
5
Check that the "READY" indica-
tor is illuminated.
The vehicle cannot be driven if the
"READY" indicator is off.
■
If the hybrid system does not start
●
The immobilizer system may not have
been deactivated. (P.79) Contact
your Toyota dealer.
●
If a message related to start-up is
shown on the multi-information dis-
play, read the message and follow the
instructions.
■
When the ambient temperature is
low, such as during winter driving
conditions
When starting the hybrid system, the
flashing time of the "READY" indicator
may be long. Leave the vehicle as it is
until the "READY" indicator is steady on,
as steady means the vehicle is able to
move.
■
Sounds and vibrations specific to a
hybrid vehicle
P.74
■
If the 12-volt battery is discharged
The hybrid system cannot be started
using the smart entry & start system.
Refer to P.443 to restart the hybrid sys-
tem.
■
Electronic key battery depletion
P.120
■
Conditions affecting operation
P.136
Advertisement
Table of Contents
