20.3.3 Adjusting the blade overlap
Fig. 93: Adjusting the blade overlap
(1) - Knife
(2) - Screw
Proper setting
If the knife (2) is at the bottom dead center, the overlap is 0.5 mm.
To adjust the blade overlap:
1. Loosen the screw (2).
2. Push the knife (1) down until it overlaps with the counter blade (3)
3. Tighten the screw (2).
20.3.4 Adjusting the position and pressure of the cutting edges
Fig. 94: Adjusting the position and pressure of the cutting edges
(1) - Knife
(2) - Knife holder
The knife (2) should be somewhat diagonal to the counter blade (3).
The knife (2) should cut reliably with the least possible pressure.
106
①
②
by 0.5 mm.
②
③
Special machines
①
(3) - Counter blade
①
④
(3) - Screws
(4) - Counter blade
Service Instructions 867 - 04.0 - 10/2019
③