DURKOPP ADLER 867 Service Instructions Manual page 48

Fig. 30: Aligning the needle bar linkage sideways (2)
(5) - Arm shaft crank
(6) - Threaded pins
5. Loosen the threaded pins (6) on the arm shaft crank (5).
Important
6. Move the needle bar linkage (4) sideways such that the needle pierces
7. Push the set collars (2) inwards as far as they will go and tighten them.
8. Tighten the threaded pins (1).
9. Align the thread lever (7) exactly in the middle of the slot.
10. Tighten the threaded pins (6).
Order
Then check the following settings:
• Looping stroke position ( p. 50)
• Distance between hook and needle ( p. 49)
46
⑤
⑥
Make sure that the threaded pins stay on the surface.
exactly in the center of the needle hole (3) for the feed dog.
Aligning the needle bar linkage
(7) - Thread lever
Service Instructions 867 - 04.0 - 10/2019
⑦