Adjusting The Adjusting Disk Relative To The Arm Shaft Crank - DURKOPP ADLER 171 Service Instructions Manual

Adjusting the adjusting disk relative to the arm shaft crank

4
Fig. 2: Adjusting the adjusting disk relative to the arm shaft crank
(1) - Slot
(2) - Locking peg
Proper setting
The deepest slot A of the adjusting disk is in line with the slot in the arm
shaft crank.
To adjust the adjusting disk relative to the arm shaft crank:
1. Loosen the screws of the set collar.
2. Insert the locking peg (2) into the slot (1) of the arm shaft crank.
3. Turn the handwheel until the locking peg (3) can be inserted into
4. Move the arm shaft crank to the right until it makes contact with the arm
5. Tighten the screws of the set collar.
Service Instructions 171/173 - 00.0 - 01/2020
Adjusting the adjusting disk relative to the arm
shaft crank
CAUTION
Risk of injury from moving parts!
Crushing possible.
Switch off the machine before you adjust the
adjusting disk.
① ②
The set collar is on the left next to the upper toothed belt wheel.
the deepest slot A of the adjusting disk ( p. 13).
shaft bearing.
③
(3) - Locking peg
15