DURKOPP ADLER 867 Service Instructions Manual page 68

Adjusting the winder spacing
Fig. 51: Adjusting the winder (2)
(3) - Winder lever
(5) - Thread-pulling knife
(6) - Winder spindle
(7) - Right-hand screw hole
Fig. 52: Adjusting the winder (3)
(11) - Marking for XXL hook
To adjust the winder spacing:
7. Turn the winder spindle (6) such that the thread-pulling knife (5) is at
8. Loosen the threaded pin in the block (8).
9. Adjust the winder lever (3) such that the upper arm is above the marking
 The distance between the winder lever and the outer thread on the
10. Adjust the block (8) such that it is resting against the locking disk (9).
11. Adjust the block (8) such that its distance to the winder wheel (10) is
12. Tighten the threaded pin in the block (8).
66
⑤
⑥
⑦
the top right and is facing the right-hand screw hole (7).
for the XXL hook (11).
bobbin is 2 – 3 mm.
0.5 mm.
⑩ ⑨
③ ⑧
(8) - Block
(9) - Locking disk
(10) - Winder wheel
⑪
Service Instructions 867 - 04.0 - 10/2019
Winder
⑤
⑥