DURKOPP ADLER 867 Service Instructions Manual page 73

Thread trimmer
Important
Screw the 4 threaded pins (3) tightly in place on the set collar (2) before
you loosen the threaded pins (5). The set collar (2) and control cam (4) are
both mutually used as a stop and must not be loosened at the same time.
6. Loosen the threaded pins (5).
7. Press the actuating lever (7) against the solenoid (9).
8. Turn the control cam (4) such that its widest extent (6) is at the top,
9. Move the control cam (4) such that the distance between its widest
10. Tighten the threaded pins (5).
11. Loosen the clamping screw (8) on the actuating lever (7).
Fig. 58: Adjusting the cutoff curve (2)
(10) - Screw
(11) - Counter blade
(12) - Thread-pulling knife
12. Turn the thread-pulling knife (12) so that the circle mark is exactly next
13. Tighten the clamping screw (8) on the actuating lever (7) such that
14. Loosen the threaded pins (3) on the set collar (2).
15. Push the set collar (2) to the right as far as it will go and against
16. Check the looping stroke position ( p. 50).
17. Tighten the threaded pins (3) on the set collar (2).
Service Instructions 867 - 04.0 - 10/2019
next to the roller (1).
extent (6) and the roller (1) is 0.1 mm at most.
⑩
⑪
⑫
to the tip of the counter blade (11).
the actuating lever (7) has no axial play.
the control cam (4).
(13) - Screw
(14) - Hook thread clamp
(15) - Screw
⑮
⑭
⑬
71