Working basis
Fig. 10: Locking the machine in place (2)
(1) - Locking peg
(4) - Arm shaft crank
Locking the machine in place
To lock the machine in place:
1. Remove the plug from the locking slot (5).
2. Turn the handwheel until the appropriate slot is in front of the locking
3. Insert the locking peg (1) with the appropriate end into the slot.
Removing the lock
To remove the lock:
1. Pull the locking peg (1) out of the slot.
2. Insert the plug into the locking opening (5).
Service Instructions 867 - 04.0 - 10/2019
④
opening (5):
• Small slot at handwheel position 0°
• Large slot at handwheel position 200 – 205°
⑤
①
(5) - Locking opening
23