Avaya G430 Manual page 353

2. Use the rtp-stat event-threshold command to set thresholds on QoS
RTP statistics application
About this task
When you enable the RTP statistics application on the Branch Gateway, the application starts
to collect QoS data from the VoIP engines and stores the data in the Branch Gateway RAM,
which holds a limited history of RTP session entries. The VoIP engine also starts to perform
and report UDP traceroutes.
Session data and automatic session traceroute results can be viewed using the CLI.
Related topics:
Enabling the RTP statistics application
Resetting the RTP statistics application
Procedure
Enter rtp-stat-service.
Admin level access is required in order to use the rtp-stat-service
command.
For example:
Gxxx-001# rtp-stat-service
The RTP statistics service is enabled (default: disabled)
Administering Avaya G430 Branch Gateway
For example:
Gxxx-001(super)# rtp-stat thresholds echo-return-loss 5
Done!
With this example configuration, if echo-return-loss is sampled higher than 5 dB
during an RTP session, the echo-return-loss event counter increments.
events.
For example:
Gxxx-001(super)# rtp-stat event-threshold echo-return-loss 2
Done!
With this example configuration, if echo-return-loss is sampled over its threshold
more than twice during an RTP session, the application considers the session to
have QoS faults.
Enabling the RTP statistics application
Note:
on page 353
on page 354
Monitoring applications
October 2013 353