Avaya G430 Manual page 138

Standard Local Survivability (SLS)
Enabling SLS
Procedure
To enable SLS on the Branch Gateway, enter set sls enable
If you enable SLS and then performed additional administration, you must first
disable SLS and then re-enable it. This causes the SLS application to resynchronize
its administrative database with the Branch Gateway's global CLI command
database.
The Branch Gateway responds with the message, Survivable Call Engine is
enabled.
Disabling SLS
About this task
.
Procedure
To disable SLS on the Branch Gateway, enter set sls disable
The Branch Gateway responds with the message Survivable Call Engine is
disabled.
Activating changes in SLS
About this task
To activate changes you make in SLS, use the disable and enable SLS commands together.
To activate changes in SLS, perform the following steps:
Procedure
1. Make any changes to SLS administration desired.
2. While still in SLS mode, enter set sls disable
138 Administering Avaya G430 Branch Gateway
Note:
The Branch Gateway responds with the message Survivable Call Engine
is disabled.
Comments? infodev@avaya.com
October 2013