Avaya G430 Manual page 201

set port speed
show port auto-
negotiation-
flowcontrol-
advertisement
show port edge state
show port flowcontrol
set port duplex
set port edge admin
state
set port enable |
disable
set port flowcontrol
set port level
set port name
set port negotiation
set port speed
show port edge state
Administering Avaya G430 Branch Gateway
Command
Command
Description
Set the speed of a port or range of ports
Display the flow control advertisement for a Gigabit
port used to perform auto-negotiation
Display the edge state of a port
Display port flow control information
Description
Configure the duplex type (full or half-duplex) of an
Ethernet or Fast Ethernet port or range of ports
Determine whether the port is an edge port, for the
purposes of RSTP (Rapid Spanning Tree Protocol)
Edge port is a treatment assigned to ports for the
purposes of RSTP (Rapid Spanning Tree Protocol).
For more information about using this command and
RSTP configuration in general, see Rapid Spanning
Tree Protocol (RSTP).
Enable or disable a port or a range of ports
Set the send/receive mode for flow control frames
(IEEE 802.3x or proprietary) for a full-duplex port
Each direction (send or receive) can be configured
separately. Use the show port flowcontrol command
to display port flow control information.
Set the default packet priority level for untagged
packets
Packets traveling through a port set at normal priority
should be served only after packets traveling through
a port set at high priority are served.
Configure a name for a port
Enable or disable auto-negotiation on the port
This command applies to the Fast Ethernet port.
When negotiation is enabled, the speed and duplex of
a Fast Ethernet port is determined by auto-
negotiation. If negotiation is disabled, the user can set
the speed and duplex of a Fast Ethernet port.
Set the speed of a port or range of ports
An error message is generated if you attempt to set
the speed when auto-negotiation is enabled.
Display the edge state of a port
Switch Ethernet port configuration
October 2013 201