Exposure Recalibration When Scanning - Canon imagePRESS C1+ Reference Manual

Exposure Recalibration When Scanning

When the optional Feeder (DADF-R1) is attached, scanning a curled original that is placed on
the platen glass may result in density unevenness on the left and right edges. This is because
the original is not placed flat on the platen glass. This may be improved by adjusting the density
level (up to approximately 20 mm) of the left and right edges of the paper.
IMPORTANT
[Exposure Recalibration when Scanning] is displayed only if the settings are made available by your
local authorized Canon dealer. Even if [Exposure Recalibration when Scanning] is displayed, do not
allow anyone to change the settings except for the system manager. For more information on changing
the settings, contact your local authorized Canon dealer.
6
1
2
6-92
Device Management Settings
Left Edge
➞ [System Settings] ➞ [Device Management Settings] ➞
Press

[Exposure Recalibration when Scanning].

Press [-] or [+] under <Left Edge> or <Right Edge> to set the exposure
recalibration.
Paper
(A3 or 11" x 17")
Density Unevenness
Right Edge