Canon imagePRESS C1+ Reference Manual page 360

4
6
5
6-76
Device Management Settings
NOTE
The following is the procedure if [Scanner + Printer] is selected for gradation adjustment. If
[Printer Only] is selected, setting the output test print onto the platen glass is not required. If you
press [Start], test print and recalibrations are made automatically.
Press [Test Print 1].
If the paper which is appropriate for the test print is not loaded in a paper source, a message
asking you to load the appropriate paper appears. In this case, load the appropriate paper in a
paper source.
Place the output test print 1 on the platen glass.
Place the test print face down on the platen glass with the black and magenta side at the front
side of the platen glass.
NOTE
If the optional Feeder (DADF-R1) is attached, place the test print face down and stack
approximately 20 sheets of blank paper on top of it for a more precise gradation adjustment.