Adjusting The Machine; Zoom Fine Adjustment; Saddle Stitch Staple Repositioning - Canon imagePRESS C1+ Reference Manual

Adjusting the Machine

This section describes how you can make fine adjustments to the settings of the machine, such
as making a fine adjustment to the printed image and the page number or watermark position.
It is recommended that you perform an Automatic Gradation Adjustment and clean the machine
regularly.

Zoom Fine Adjustment

When you print a copy or a document from an inbox, a slight difference in size may occur
4
between the size of the original image, and the size of the copied/printed image. In this case,
you can perform a fine adjustment to compensate for this difference.
1
2

Saddle Stitch Staple Repositioning

You can reposition the stapler of the saddle stitcher unit after clearing a staple jam, or after
replacing the staple cartridge. Saddle stitch staple repositioning works by feeding several
sheets of paper into the saddle stitcher unit and stapling them together.
CAUTION
If transparencies are loaded in a paper drawer, make sure to pull out that paper drawer
slightly so that transparencies are not fed for the saddle stitch staple repositioning
procedure. Damage to the machine may occur if transparencies are fed during this
procedure.
4-70

Adjusting the Machine

➞ [Adjustment/Cleaning] ➞ [Zoom Fine Adjustment].
Press
Press [-] or [+] to adjust the percentage (%) ➞ press [OK].
If you are making an adjustment to either the X (horizontal) or Y (vertical) direction, press [-] or
[+] to enter a value for that direction only.