Isdn Settings - Furuno FELCOM251 Operator's Manual

6.7

ISDN Settings

Set for the equipment that is connected to the USB port via "USB-RS232C Converter".
1. Referring to section 6.1, login as an Administrator.
2. Click [Admin] in the menu bar.
3. Click [ISDN Settings] to show the [ISDN Settings] menu.
4. Referring to the table below, set up the ISDN service.
Item
Serial Communication
Baud rate
Parity
Flow Control
Auto Connection
Auto connection
when incoming
Ring times
5. Click the [Apply] button.
The message "Applied." appears.
6. Click the [Close] button to close the message.
Shows the preset baud rate.
The setting cannot be changed.
Shows "None".
The setting cannot be changed.
Shows "Hardware".
The setting cannot be changed.
Turn the setting on to connect ISDN automatically when receiving
an incoming call, then the data communication starts via the USB
port.
Set the ring tone number when receiving the ISDN call until auto-
matic connection.
This menu appears in grey when turning the [Auto connection
when incoming] menu off.
6. SETTINGS ON WEB INTERFACE
Description
6-15