How To Set The Ip Filter - Furuno FELCOM251 Operator's Manual

6. SETTINGS ON WEB INTERFACE
8. Click the [Save] button.
The message "Applied." appears.
9. Click the [Close] button to close the message.
6.8.7

How to set the IP filter

An IP filter helps to regulate access to/from specified IP addresses.
Note: To setup an IP filter, [Group Type] must be set to other than [Bridge].
You can setup the IP filter with the following procedure.
1. Referring to section 6.1, login as an Administrator.
2. Click [Admin], [Network Settings], [WAN], then [Groups].
3. Click the [Settings] button for the group whose IP filter you want to setup.
4. Click [IP Filter].
Item
Add filter button
Delete button
Pri.
Action
Dir
Src. Addr.
Dest. Addr.
Protocol
Area
6-38
Filtered domains appear in the DNS Filter List.
Registered/available IP filter count Registered/available IP filter count Registered/available IP filter count
Create a new IP filter Up to 100 filters can be created. The cre-
ation pop-up window appears.
Delete items with check-marks [ ].
Put a [ ] in the box on the left side of the item to delete.
To select all IP filters, put a [ ] in the box beside the [Pri.] title.
Shows the priority.
The smaller the number the higher the priority.
Shows the IP filter action.
Shows direction in which the IP filter is applied.
Shows the source address.
If not set, "Anywhere" appears.
Shows the destination address.
If not set, "Anywhere" appears.
Shows the IP filter protocol.
• If [Protocol] is [Any], Shows the protocol number.
• If [Protocol] is [TCP/UDP]: Shows the port range.
• If [Protocol] is [TCP], [UDP]: Shows the port range or port
numbers for [Dest. Addr.] and [Src. Addr.].
Description