Logging On To The Software And Accessing Global Configuration Mode; Switching From The Acli Back To The Cli - Avaya 8800 User Interface Fundamentals

ACLI procedures
You must reboot the switch for this change to take effect. After you reboot the switch,
access the ACLI using Telnet, rlogin, or the local console port.
Logging on to the software and accessing global
configuration mode
After you access the ACLI, you can do the following:
• Log on to the software using the default user name and password.
• Access global configuration mode.
Procedure steps
1. At the login prompt enter the default value.
2. At the password prompt, enter the default password.
3. To access privExec mode, at the prompt ERS-8610:5, enter enable.
4. To access global configuration mode, at the prompt, enter configure

Switching from the ACLI back to the CLI

The config.cfg file for the CLI and the config.cfg file for the ACLI are not compatible. If you
decide to change the CLI mode to ACLI, or the reverse, you must use the config.cfg file for the
selected mode.
Prerequisites
• You must be in global configuration mode to switch from the ACLI to the CLI.
Procedure steps
Switch from ACLI to CLI using the following commands:
40 User Interface Fundamentals
Important:
terminal.
Comments? infodev@avaya.com
July 2013