Avaya 8800 User Interface Fundamentals page 13

- OSPF
- RIP
- VRRP
- VRF
From either the global configuration mode or the Interface configuration mode, save all of the
configuration parameters (both global and interface) to a file. The default name for the
configuration parameter file is config.cfg. You can also use alternative file names.
The following table lists the ACLI command modes, the prompts for each mode, the
abbreviated name for each mode, and how to enter and exit each mode.
Table 1: ACLI command modes
Command
mode
User EXEC
privileged
Exec
Global
configuration
Interface
configuration
User Interface Fundamentals
Prompt
ERS-8600:5>
ERS-8600:5#
ERS-8600:5<config>#
ERS-8600:5<config-if>#
Mode name Command mode or enter/
exec This mode is the default
command mode and does
not require an entrance
command. To exit the ACLI,
enter
privExec Enter
privileged Exec mode from
user EXEC mode. Enter
disable
privileged Exec mode and
enter User EXEC mode. To
exit the ACLI, enter
logout
config Enter
Global configuration mode
from privileged Exec mode.
Enter
configuration mode and
enter privileged Exec
mode. To exit the ACLI,
enter
config-if Entry into this command
mode depends on the type
of configured interface.
Enter
{atm|FastEternet|
GigabitEthernet|
Loopback|mlt|pos|
VLAN}
configuration mode from
Global configuration mode.
exit mode
logout .
enable to enter
to exit
.
configure to enter
exit to exit Global
logout
.
interface
to enter Interface
July 2013
ACLI
13