Switching From Acli To Cli For An Ha-Cpu From Factory Defaults; Switching From Acli To Cli For An Ha-Cpu From Existing Configurations - Avaya 8800 User Interface Fundamentals
Ethernet routing switch
Hide thumbs
Also See for 8800:
- Troubleshooting manual (484 pages) ,
- Planning and engineering, network design (327 pages) ,
- Planning and engineering (306 pages)
Table of Contents
Advertisement
3. Boot the secondary SF/CPU first and then boot the primary SF/CPU.
Switching from ACLI to CLI for an HA-CPU from factory
defaults
Use the following procedure to change an HA-CPU from ACLI to CLI from factory defaults.
Prerequisites
• You must be in global configuration mode to switch from the ACLI to the CLI.
Procedure steps
1. Set the factory defaults flag on the switch and save the boot configuration.
2. Boot the secondary SF/CPU in CLI mode.
3. Boot the primary SF/CPU in CLI mode.
Switching from ACLI to CLI for an HA-CPU from existing
configurations
Use the following procedure to change an HA-CPU from ACLI to CLI from existing
configurations.
User Interface Fundamentals
config boot flags acli true
The secondary SF/CPU comes up in CLI mode.
Both the secondary SF/CPU and primary SF/CPU are now in CLI mode.
Switching from ACLI to CLI for an HA-CPU from factory defaults
July 2013
47
Advertisement
Table of Contents
