Switching From Acli To Cli For A Dual Cpu (Non-Ha) From Factory Defaults; Switching From Acli To Cli For A Dual Cpu (Non-Ha) From Existing Configurations - Avaya 8800 User Interface Fundamentals

Switching from ACLI to CLI for a dual CPU (non-HA) from
factory defaults
Use the following procedure to change a dual CPU from ACLI to CLI from factory defaults.
Procedure steps
1. Set the factory defaults flag on the switch and save the boot configuration.
2. Boot the secondary SF/CPU in CLI mode.
3. Boot the primary SF/CPU in CLI mode.
Switching from ACLI to CLI for a dual CPU (non-HA) from
existing configurations
Use the following procedure to change a dual CPU from ACLI to CLI from existing
configurations.
Prerequisites
• You must be in global configuration mode to switch from the ACLI to the CLI.
Procedure steps
1. Save the configurations in CLI mode.
2. Enter the following command:
User Interface Fundamentals

Switching from ACLI to CLI for a dual CPU (non-HA) from factory defaults

The secondary SF/CPU comes up in CLI mode.
Both CPUs are now in CLI mode.
The following is an example:
save config file cli.cfg mode cli
July 2013 45