Table of Contents
Advertisement
12
SOFTWARE(S) UPDATING
The software of the remote control RCC as well as the Xtender inverter/chargers, the
communication module RS-232 (Xcom-232i), the Xcom-SMS and the battery monitor (BSP) can be
updated in order that they integrate all new functionalities.
All software updates are available in the technical area of our website www.studer-
innotec.com/support.
12.1 U
PDATING PROCESS
For more information about the updating process, please refer to the document
"Updating procedure" available on: www.studer-innotec.com/support.
Remember to turn off all Xtenders (putting them on "off") before inserting the
micro SD card to carry out an update. If not manually performed, the updating
process will automatically stop all Xtenders connected to the communication bus.
To carry out an update, insert the micro SD card (containing the latest software version) in the
Xcom-SMS module's micro SD card reader. Before starting the updating process, the system
automatically checks the compatibility between the device and the software present on the
micro SD card. The micro SD card must not be removed until the end of the updating process. If
for some reason the updating process is interrupted, reinsert the SD card to let the process finish.
The updating process can take between 3 and 15 minutes. During this period, it is
possible that the signalisation LED does not respect exactly the cyclical ratio
described. The updating is finished once the signalisation LED stops blinking red for
at least 20 seconds.
The updating of a remote control RCC-02/-03, Xcom-232i/-SMS/-LAN/-GSM must be
done directly on the connected device.
User manual
V 1.0.0
Studer Innotec SA
Xcom-SMS
43
Advertisement
Table of Contents
