Table of Contents
Advertisement
Studer Innotec SA
Xcom-SMS
7.5
O
PERATING REPORT BY
The Xcom-SMS module has the possibility to generate and send operating reports from the system.
This way you could know the state of your batteries, the input and output power of your system as
well as the state of the auxiliary relays.
There are two types of reports: one condensed "short" report and one detailed "long" report. It is
not possible to configure the contents of the two types of report.
Several users (up to 8) may subscribe to each of these reports. The sending of each report may
even be defined with a specific SMS. All subscribers will receive their rapport at the same time, the
same day.
By SMS it is possible to:
Subscribe/ unsubscribe to the "short" or the "long" report service
Define which days of the week as well as the time each report will be sent.
Ask to receive one of the two reports immediately without being part of the mailing list.
Ask to receive the mailing list to both types of reports
7.5.1 Contents of the report
Both reports contain more or less the same information. However, the "short" report presents the
information in a brief way whereas the "long" report presents the same information in a much more
detailed way (with details of each device within the system).
The following information will be found in the reports:
State of the system (on/off)
State of the battery (SOC, temperature, etc.)
The input and output power of your system
The energy input and output of your system
The PV voltage of your system
State of the auxiliary relays of the Xtenders
Sending a "long" report (indicated as r2 in the commands as from now) demands
several SMS from the telephone network's point of view. As a matter of fact the
message can contain up to 1600 characters for a large system (>20 devices). The
cost for sending such a message may reach the cost of 10 SMS. For a mid-size
system (<10 devices) the report may require 3 to 5 SMS.
7.5.2 Subscribe/Unsubscribe to reports
This command makes it possible to subscribe or unsubscribe to one of the two reports. The user
that subscribes to this service will automatically receive the selected operating report in
accordance with the sending configuration. A user that unsubscribes to this service will no longer
receive the operating report.
Format:
report (<n>) <state> <tel>
(<n>)
Optional
Report identifier based on this format:
r1 :
r2 :
If not specified the report 1 ("short") is used by default
24
SMS
rapport 1 ("short")
rapport 2 ("long")
V 1.0.0
User manual
Advertisement
Table of Contents
