Event Based Sms; Subscribe/Unsubscribe To Events - Studer Xcom-SMS User Manual

7.6 E
VENT BASED
The components of your system indicate when various events occur by sending messages. With
the Xcom-SMS it is possible to select specific events to be informed about via SMS. You could for
instance be notified when the battery is discharged.
The messages are classified in categories. You can chose to receive messages by category or
target a certain type of message.
There are four different types of messages:
 Notification: general information on the functioning of the system
 Alarm: an event that may cause the system to malfunction or to shut down if not
resolved soon
 Error: a function of the system has been deactivated
 Halted: The system had to be stopped as a major event is preventing its operation.
You will find the complete list of events as well as their category in the "RCC-02/-03 Quick guide"
available as .pdf on your SD card.
By default the Xcom-SMS sends all messages from the categories error and halted.
Several users (up to 8) can subscribe to the event service. They will all receive the same messages
at the same time.
By SMS, it is possible to:


Subscribe/unsubscribe to events.

Configure the sending of SMS by category.

 Configure the sending of SMS for one or many specific events.
 Receive the list of subscribers to events
 Receive the list of events for which sending is authorised.
7.6.1 Subscribe/Unsubscribe to events
This command makes it possible to subscribe or unsubscribe to events. The user that subscribes to
this service will automatically receive an SMS for each event that happens at the system.
Format: event <state> <tel>
<state> Mandatory
Active or deactivated
on:
off:
<tel> Mandatory
A phone number with country code (max. 15 digits)
Ex. Country code for Switzerland preceded by +:
Ex. Country code 00 for Switzerland: 0041791234567
Example of command subscribe/unsubscribe to events:
Command
event on +41791234567
event off +41791234567
User manual
SMS
subscribe
unsubscribe
Functioning of the Xcom-SMS
The events that occur on the system will be sent automatically by
SMS to phone number: +41791234567
The events that occur on the system will no longer be
automatically sent by SMS to phone number: +41791234567
V 1.0.0
Studer Innotec SA
Xcom-SMS
+41791234567
29