Table of Contents
Advertisement
7.9.2 Reading parameters
This command makes it possible to receive (read) one or several parameter values of your system.
Format:
param ? <num>(,<num>)
<num>
At least 1, maxi 10
Parameter number (see the RCC-02/-03 Quick guide in .pdf available on the micro
SD card)
The maximum number of parameters <num> is limited to 10.
Example of "param" commands:
Command
param ? 1138
param ? 1552, 1126
Example of SMS reading two
parameters successfully.
7.10 A
CCESS TO THE SYSTEM
Your system constantly uses electrical quantities and diverse information for its operation which is
called "user information". With the Xcom-SMS you can access those at any time, for instance to
find out the current state of charge of your battery.
7.10.1
Reading user information
This command makes it possible to read one or several user information from the system.
Format:
info ? <num>(,<num>)
<num>
At least 1, maximum 10
Information number to read (see the RCC-02/-03 Quick guide in .pdf available on
the micro SD card)
Maximum number of <num> is limited to 10.
Example of "info" commands:
Command
info ? 3028
info ? 3000, 3005
User manual
Functioning of the Xcom-SMS
Indicates the Xtender's battery charge current limit
Indicates the kind of network loss detection (AC-In) and the state of
the Smart-Boost.
'
S USER INFORMATION BY
Functioning of the Xcom-SMS
Reads the Xtender's operating mode
Reads the Xtender's battery voltage and battery current.
V 1.0.0
123456 param ? 1138, 1552
Xcom-SMS P1138: Battery
charge current=50.0Adc,
P1552:Type of detection of
the grid loss (AC-In)=Rapid
SMS
Studer Innotec SA
Xcom-SMS
37
Advertisement
Table of Contents
