Table of Contents
Advertisement
Studer Innotec SA
Xcom-SMS
11
DATALOGGER
The communication module Xcom-SMS offers a function that allows recording many electrical
values of your system over a long time.
With this function you can for instance follow the energy consumption and the battery voltage,
or see the power cuts, the state of the auxiliary relays, the input currents and voltages, the output
powers etc...
This enables you to work out statistics, to check the system operation or its sizing, to verify the loads
behaviour, to anticipate or to detect failures.
11.1 F
UNCTIONING
If the data logger is activated, a file is created at midnight every day on the SD card inserted in
the Xcom-SMS. This file contains the data of the Xtender system components as well as the
recordings of the system electrical values, minute after minute. The file is registered in CSV format
that can be read by many types of software. The file name integrates the date of the measure in
this form: LGyymmdd.csv. In case no SD card was inserted, the daily data will be lost.
Updating the software of the Xcom-SMS will result in the loss of the current day's data.
11.2 A
NALYSIS AND VISUALIZATION OF THE DATA WITH THE
TOOL
Attached to this function, Studer Innotec offers free of charge an analysis tool in the form of a
file type Microsoft® Excel® 2007 which allows reading specifically the CSV files generated by the
remote control. This tool shapes and gathers the data of each Xtender and then displays them
graphically. In this way the data become readable and understandable at a glance.
These files can be downloaded for free on www.studer-innotec.com/support.
42
V 1.0.0
X
TENDER DATA ANALYSIS
User manual
Advertisement
Table of Contents
