Table of Contents
Advertisement
Studer Innotec SA
Xcom-SMS
7.9.1 Writing parameters
Your system function with a number of parameters of which most are adjustable. This command
makes it possible to change (write) one or several of the system's parameters.
If you try to change a parameter which is not accessible with the Xcom-SMS, you will receive an
error message from the communication module Xcom-SMS (for example the parameter 5012).
In a system with several devices, changing a parameter is valid for all devices. A complete list of
parameters is available in the RCC-02/-03 Quick guide (pdf-file on the supplied SD card).
In cases where the activation of a parameter will enable the execution of a
function on a device, the format is somewhat unusual. In the manuals, these
parameters don't have a possible value. (For example Xtender parameter 1142:
force a new cycle). In order to activate the parameter's function you have to write
"1" for this specific parameter.
Format:
param <num>=<value>(,<num>=<value>)
<num>
Parameter number (see the RCC-02/-03 Quick guide in .pdf available on the micro
SD card)
<value>
Assigning a value to a parameter, respecting its specific format.
The number of parameters <num>=<value> is limited to 10.
Example of "param" commands:
Command
param 1138=50
param 1552=rapid, 1126=no
param 1142=1
Example of SMS changing
three parameters successfully.
Example of SMS changing three
parameters with error and the
corresponding reply.
36
Functioning of the Xcom-SMS
Limits the Xtender's battery charge current to 50 Adc.
Sets the kind of network loss detection (AC-In) to "rapid" and
prohibits Smart-boost on the Xtenders.
Force a new battery cycle on the Xtenders.
Xcom-SMS P1138:ok,
P1552:ok, P1126:ok
123456 param 1138=50,
1552=rapide, 1126=n
Xcom-SMS P1138:ok,
P1552:ok, P1126:Error
(193): Invalid value
V 1.0.0
123456 param 1138=50,
1552=rapid, 1126=no
User manual
Advertisement
Table of Contents
