Wiring And Automatic Power-Up - Studer Xcom-SMS User Manual

Communication module

Table of Contents

1. PIN Code:

Here you should enter the PIN code supplied with your micro SD card. It's a code of 4 to 6

digits. This code is mandatory except if it has been removed, using a phone, or if the SIM

card comes without a PIN code.

2. SIM Card Phone Number:

Here you should enter the phone number assigned to your micro SIM card. We

recommend to enter the international phone number format indicating the country

code from where the system will be operating. In the example above the country code is

+41, which is the country code for Switzerland.

3. Owner Phone Number:

Here you should enter the phone number to which messages and reports from your

system will be sent as well as the automatic message that confirms that the configuration

has been successful. It is recommended to use an international format with the country

code of the country where the system will be operating.

4. User Key:

Here you should enter the access code that you would like to use when accessing the

system in the future. This code (<key>) will be necessary when sending messages to your

system. Find out more about its signification and format, in chapter 6.2. This code is

mandatory and you will need it in order to generate the configuration files. Remember to

write down this code, without it it's impossible to communicate with your Xcom-SMS.

5. When all requested fields are filled out, press "Generate" to create the configuration files.

5. A window will automatically confirm the successful file generation. Click on OK, the

configuration of your SD card is completed.

You may now remove the SD card from your computer and insert it into the Xcom-SMS.

4.2

IRING AND AUTOMATIC POWER

Wiring the system is easy but requires meticulous attention in order to facilitate the smooth

functioning of the system. Once connected to your system the power-up will be automatic.

The SD card delivered with the Xcom-SMS contains a software update for all the

devices of the system (Xtender/VarioTrack/VarioString/...). When the Xcom-SMS is

connected, it will verify the software version of each device connected to the

communication bus. If the software version on the SD card is more recent than the

existing version on the devices, they will be updated which will cause a restart (with

interruption of operation) in the corresponding devices.

User manual

V 1.0.0

Studer Innotec SA

Xcom-SMS

Table of Contents