Blinking Codes And Push Button - Studer Xcom-SMS User Manual

5

BLINKING CODES AND PUSH BUTTON

Key Description
(a) Push button
This button enables 3 functions.
1. Pressing the button for less than 0.8 s:
2. Pressing the button for 0.8 s to 3 s:
3. Pressing the button for 3 s to 6 s:
4. Pressing the button for 6 s to 9 s:
Pressing the button for more than 9 seconds does nothing. After 9 s the
signalisation LED (b) behaves normally and you can let go of the button without
any changes in behaviour. For example, if you wish to save all files on the SD
card but you accidentally hold the button more than 6 s, you can keep holding
the button more than 9 s, then let go without changing any functions.
(b) Bicoloured signalisation LED green/red (cable side)
The signalisation LED indicates different functions using colour and frequency of
blinking. Hereafter each function is described in detail.
Push button (absolute priority)
Pressing the push button will have a direct impact on the blinking of the LED. The
push button has an absolute priority on the functioning of the LED over other
indications described hereafter. These are listed by priority, from the highest to
the lowest priority.
User manual
Figure 5.1: Front and isometric view of the Xcom-SMS
Sends a test-SMS to the phone number set in the Xcom-configuration. The
signalisation LED (b) does not indicate this function and behaves
normally.
No function. However the signalisation LED (b) is turned off. If you let go of
the button now nothing will happen and the Xcom-SMS will continue to
function normally.
Saves all files on the SD card. You should let go of the button when the
signalisation LED (b) is green.
Deletes the Xcom-SMS configuration (no more events or reports will be
sent). You should let go of the button when the signalisation LED (b) is red.
This action will not change the access code.
V 1.0.0
Studer Innotec SA
Xcom-SMS
15