Table of Contents
Advertisement
Studer Innotec SA
Xcom-SMS
Example of a "report" command to receive a list of event subscribers:
Command
event on ?
Example of SMS to receive a list
of event subscribers.
7.6.5 Receive the state of transmission of events
There are more than 200 events that may occur on your Studer system. It is possible to request the
state of transmission of events using the following command.
Format:
event ?
The reply to this command is a long SMS with a list of "0" and "1". Each position represents an event. The
events are listed in groups of ten events. If a position is set to "1", this indicate that if the corresponding
event occurs on the system an SMS will be sent.
Example of SMS to receive the
state of transmission of events.
Sending the state of transmission of events requires several SMS from a phone
operator's point of view. As a matter of fact this message will require approximately
500 characters. The cost for sending such a message is equivalent of 3 to 4 SMS,
independently of the size of the system.
32
Functioning of the Xcom-SMS
Sends a list of subscriptions to the event service
V 1.0.0
123456 event on ?
Xcom-SMS
- cmd event:
subscribers =
+41791234567
+41781122338
123456 event ?
Xcom-SMS
- cmd event: get
0 to 9:
0000000011
10 to 19:
0000111001
20 to 29:
1011011111"
30 to 39:
1111101000
40 to 49:
0110000000
...
User manual
Advertisement
Table of Contents
