Configuring A Network Interface - Sony XVS-9000 User Manual

The NFS server address is displayed in the "NFS
Server Address" field.
3
To register the setting as a power-on default, press
[Define].
4
Check the message, then press [Yes].
Mounting the NFS server
In the Engineering Setup >System >Network Config menu
(7311), press [NFS Mount], turning it on.
The configured NFS server is mounted, ready for use.
Note
Resetting the menu panel will unmount the NFS server.
To use an NFS server after resetting the menu panel,
mount the server again.

Configuring a Network Interface

You can configure the interface for a network connector
board.
Note
Only slots in which a network connector board (XKS-
T8110/XKS-Q8111/XKS-T8165/XKS-Q8166) is
installed are configurable.
Resetting network settings
1
In the Engineering Setup >System >Network Config
menu (7311), press [Net I/F Initialize].
The Net I/F Initialize menu (7311.1) appears.
2
In the <Device> group, select the target switcher to set.
3
In the status area, select the target slot to set.
To select all slots, press [ALL].
4
Press [Factory Reset].
To reset a connector board only
Press [Reset].
5
Press [Execute].
6
Check the message, then press [Yes].
Configuring network settings
You can configure network interface and LSM (Live
System Manager) settings.
1
In the Engineering Setup >System >Network Config
menu (7311), press [Net I/F Setting].
The Net I/F Setting menu (7311.2) appears.
2
In the <Device> group, select the target switcher to set.
The status area shows the configuration information of
each network and the MAC address of the selected
network interface.
The slot number of the network connector board and
the following network names are displayed in the
"LAN" field.
• Main network: 1-1, 2-1, 3-1, 4-1
• Sub network: 1-2, 2-2, 3-2, 4-2
To display the latest settings
Press [Refresh].
3
In the status area, select the target network to set.
To select multiple networks, set the [Num] parameter.
To select all networks, press [ALL].
To select multiple networks with the [Num]
parameter
Specify the number in the [Num] parameter. The
specified number of networks are selected from the
currently selected network number.
Note
When multiple networks are selected, if the network
with the lowest number is a main network, only main
networks are the target for configuration. Likewise for
sub networks.
4
Enable or disable DHCP.
To disable, press [DHCP] in the <Network Interface>
group, turning it off.
To enable, press [DHCP] in the <Network Interface>
group, turning it on, and skip to step 8.
Note
The DHCP settings for main and sub on a single
network are linked. Disable DHCP when not
performing the initial setup.
5
In the <Network Interface> group, press [IP Address],
and set the IP address.
Enter the IP address using the keyboard window, then
press [Enter].
If multiple networks are selected, this sets the IP
address for the network with the lowest number, and
the IP addresses of subsequent networks are
incremented by 1 for each network.
386