Effect Register Editing - Sony XVS-9000 User Manual

To select multiple registers with the [Num]
parameter
Specify the register number in the [Register]
parameter, and set the quantity in the [Num]
parameter.
The specified amount of registers is selected from the
specified register number.
5
Press [Effect Dissolve], turning it on.
6
Set the duration.
No. Parameter Adjustment
4 Eff Diss Dissolve duration
Duration
To set the duration for a temporary attribute
Set the duration for a temporary attribute set in the numeric
keypad control block using the following parameters.
No. Parameter Adjustment
5 Temp Dur Temporary attribute dissolve duration

Effect Register Editing

You can carry out the following editing on effect registers
and master timeline registers.
• Lock: Write-protect the data contents of the register.
• Copy: Copy data between registers.
• Merge: Merge the data of two registers. It is not possible
to merge master timeline registers.
• Move: Move data between registers.
• Swap: Swap the contents of two registers.
• Delete: Delete the data contents of a register.
• Name: Attach a name to a register.
Write-protecting the contents of the effect
register
Note
It is not possible to write-protect an empty register.
1
Open the Effect >Effect 1-99 >Lock menu (6222).
2
Press the region display in the upper part of the list to
display a selection window, then select the region in
the selection window.
You can select more than one region.
To select all regions, press [ALL]. To select all
switcher-related regions (M/E, P/P, User), press [SWR
ALL].
3
Press [OK].
4
Select a register.
To select all registers, press [ALL]. To select multiple
registers, set the [Num] parameter (see page 322).
5
Press [Lock], turning it on.
To release the lock
Select the register you want to unlock, and press [Lock],
turning it off.
Copying, moving, and swapping data
between effect registers
This section describes the procedure for copying data as an
example. You can move or swap data using a similar
procedure.
1
Open the Effect >Effect 1-99 >Copy/Merge menu
(6223).
The left side of the status area shows the register
number of the copy source, and the right side shows
the register number of the copy destination.
2
Press the region display in the upper part of the list to
display a selection window, then select the region in
the selection window.
Operation between regions
Operation between regions is possible in the following
cases.
• Two of the M/E-1, M/E-2, M/E-3, M/E-4, M/E-5,
and PGM/PST regions
• Two of the User1 to 8 regions of the same
configuration
• Two of the DME ch1 to ch4 (including Global)
regions
3
Select the source and destination registers.
To select all registers, press [ALL]. To select multiple
registers, set the [Num] parameter (see page 322).
4
To copy without transferring the name, in the <Copy>
group, press [W/o Name], turning it on.
5
In the <Copy> group, press [Copy].
Merging effect registers
1
Open the Effect >Effect 1-99 >Copy/Merge menu
(6223).
The left side of the status area shows a list for the
register to be placed at the back when merged. The
right side shows a list for the register to be placed at the
front when merged.
322